Cleansing Residential Concrete Floors – Helpful Tips

Concrete floors provide a stable and durable solution, but are often exposed to more grime, contamination and damage compared to other types of flooring. Cleaning residential concrete floors, both interior and garages, takes a specific approach and regular maintenance is necessary to keep all of them in the best possible condition, preserving their uniform look. That is especially the situation with stained and textured cement floors that are quite popular as flooring for certain types of premise.

General upkeep tips

Whenever using a wet cleaner, make sure you rinse it well afterwards and let it dry out before placing it away. Store the mop in a cool and dry place. Replace the mop heads as often as essential. Avoid leaving a wet mop inside the bucket.

Interior concrete floors

Sweep the floor once a week or more, in the event that needed. Use a dry mop for the daily maintenance routine. Vacuuming the floor when it’s dry is a good addition to the weekly sweeping. Use a canister type dry vac for best results.

To clean sticky grime, use a warm moist mop. The warm water helps lift up substances off the floor. Wash the mop often during the procedure. You can also use a steam machine, but avoid the commercial ones which have serious clean capabilities, with a shampoo-type function often included.

Concrete floors within garages

When working on your vehicle or even operating with automobile oils, place cardboard sheets or scrap newspapers on the floor to help catch any splatters and prevent contamination of the floor. Anytime that happens, pack up and seal the soaked up paper in a plastic bag, then treat it as a toxic waste.

If spills of a windshield fluid occurs, rinse the floor with water and use a wet mop to wash it out. Let fresh air enter in the garage occasionally possible and allow the particular wet concrete surface to dry out.
If you have any kind of concerns pertaining to where and the best ways to make use of Pathway Environmental, you could call us at our website.

Sticky grime can be removed by using a high pressure water sprinkler/sprayer as well as a stiff bristle broom. After the power sprayer does its job as well as the floor dries up, follow up by sweeping the spot with the broom, eliminating off any dirt that’s left over. You can use a larger wet vac in between to take care of standing water and debris.

One last thing, keep an eye for issues on your concrete floors regularly. Any cracks should be cleaned up with a tough wire brush or a stiff wire wheel attached to a drill, then patched up and sealed appropriately.

Leave a Reply

Your email address will not be published. Required fields are marked *